MIL installation fails after selecting the Matrox Solios Matrox Imaging Driver.
Support Forum
This forum provides answers to commonly asked technical support questions.
If your problem is urgent and/or too complex for the forum format, email support@optotherm.com and an engineer will assist you.
This question has been flagged
1
Reply
414
Views
The Matrox Solios PCIe CameraLink board is not compatible with the version of Matrox MIL that is required by Thermalyze v8 (see the Thermalyze v8 Hardware and Software compatibility table here).
Please perform one of the following options:
- Install the latest legacy version of Thermalyze v7 here.
- Contact Optotherm to quote a PCIe CameraLink board that is compatible with Thermalyze v8.