Support Forum

This forum provides answers to commonly asked technical support questions.

 If your problem is urgent and/or too complex for the forum format, email support@optotherm.com and an engineer will assist you.

This question has been flagged
1 Reply
265 Views

After functioning correctly for 2 days, a customer's PC began returning the following error messages in the dialogue box when trying to open Thermalyze:

milAppError; Licensing error.MdispAlloc Mil requires a Matrox Imaging board or a valid license. 151 15.59.07
A Matrox Solios video board or USB license key is currently not installed and therefore Thermalyze will shut down

As well as a popup window saying:

A Matrox Solios video board or USB license key is currently not installed and therefore Thermalye will shut down.

The following steps were taken to ascertain the problem:

  • Unplugging the camera and USB dongle, then plugging them back in. 
    • No change in behavior
  • Plugging in the IS640-17 Camera to a different USB port
    • This was repeated 10 times. One of these times, Thermalyze began to behave normally, but the previous errors persisted after restarting the computer. This was not able to be replicated.
  • Determined that all Ports and USB controllers in device manager were present and working normally.
  • Reinstalled all Matrox, NI, and Optotherm software.
    • No change in behavior.
  • Plugging the USB dongle into a PC that is known to work. (system 2)
    • Thermalyze was able to start and function normally on system 2.



Avatar
Discard
Author Best Answer

This issue may be caused by the PC's power supply providing insufficient power. Please try the following:

  1. Unplug all USB connectors from the ​USB ports on the front and back of the PC.
  2. Plug in the Mouse to a USB port on the back of the PC.
  3. Plug in the USB License Dongle to a USB port on the back of the PC.
  4. Plug in the ​IS640-17 Camera to a USB port on the front of the PC.
  5. Attempt to launch Thermalyze and enable Image Capturing.

If the problem persists:

  1. Switch which ports the Camera and USB License Dongle are plugged in to. ​​​
Avatar
Discard