Thermalyze Offline is used to perform post-analysis of data on remote computers and to allow colleagues to view and analyze data on their own computers.  Thermalyze offline software provides the same image analysis and file saving capabilities as the full version of Thermalyze.  The offline version however, does not have the ability to capture real-time thermal images from an InfraSight camera and therefore cannot perform real-time analyses.

The infrared camera positioning arm allows thermal imagers to be quickly placed at any position within the arm’s range.  The arm can be positioned within a 28” radius from mount and at a height of 2-24” using one extender tube (8-30” height using two extender tubes).  Thermal imagers attach with one 1/4"-20 thumbscrew.

Thermal imagers can be positioned directly downward or it can be rotated on the bracket to enable sideways or upward viewing.

The universal mount at the base of the arm can be mounted in the following configurations:

• Desk edge clamp mount

• Through desk mount

• Wall mount

The standard and large infrared camera stands allow you to adjust the vertical position of the camera and lock it in place.  They also provide a stable platform on which to place or mount the unit under test.  The platform is a wood composite and can be easily machined to mount custom fixtures.

A metric scale on the vertical post of each stand allows you to accurately position thermal imagers to a previously recorded height in order to perform repeatable tests.  Thermal imagers may be rotated on the camera mounting pad to enable sideways or angular operation.

The standard infrared camera stand is 27.5” tall and has a platform that is 16.5”x15.5”x1.125” thick.  The large infrared camera stand is 44” tall and has a platform that is 27”x24”x1.125” thick.  Thermal imagers attach with one 1/4"-20 thumbscrew.

This rack and pinion stage mounts between the infrared camera and camera mounting device (stand, tripod, positioning arm).  It enables thermal imagers to be precisely positioned in the x (30 mm travel), y (35mm travel), and z (32 mm travel) directions.  It is particularly useful when using the 35°(H)x50°(V) lens at close focus distances to zoom in on small targets.  Thermal imagers attach with one 1/4"-20 thumbscrew.

Circuit board support edges on the rails and feet are 0.062” wide and a 0.062” deep step cut allows connectors to overhang the board edge up to 3/8”.  The rails and feet can be removed to accommodate larger boards. Rails have spring action hold-down clamps that can be positioned anywhere along the length of the rails and will accommodate board thicknesses of 0.031”-0.093”.  Ruler tape, mounted on the inside of the frame, provides a reference used to record the position of the rails and feet.